![]() Basically I just need switches between VDD and +5V and between VSS and GND. I don't think a schematic would be all that helpful at this point, but let me know if you need it. Is there a way to do this? Whenever I add in a different netlist name for VDD and VSS when editing the component properties I get errors saying No power supply specified for net in Power Rail Configuration. However, for this particular circuit I am attempting to put a switch between the power supply and the chip's VDD pin, and another switch between the VSS pin and ground (I know this switch is not necessarily needed, and probably should not even be used, but this is just an experiment). So, If your device is an OR gate and there are 4 OR gates in the chip then just place 4 partys of the smae device and you get all the pins. ![]() You can then select the power supply you want to use. If all the pins except power pins are not visible then it means the device is split into A, B, C, D, like that. Its default view is a DB9-Pin Serial Port connector. You can access them by right-clicking the component, selecting "Edit properties", and going to "Hidden pins". The Proteus software has an option to interface with external modules in real-time through the COMPIM (Comport Physical Interface Module) component. I am currently working on a simple circuit involving logic gates in Proteus ISIS from Labcenter.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |